First test run!
Testing the 2m PLA windturbine

First test run!

We have succesfully tested the PLA windturbine out in the field! It went well up to 17V in a light wind, which means that the generator is performing as should…

Continue Reading First test run!
Update on 3D-printing the generator
Try if the bearing fits. If not, make the gap a bit bigger with a soldering iron

Update on 3D-printing the generator

We have been working tirelessly on printing the generator. This part is the heart of the windturbine and will fit the magnets and bearings. Hence print settings are really important…

Continue Reading Update on 3D-printing the generator
  • 1
  • 2