1m PET windturbine in development
Started printing a 1m PET-G windturbine!
We learned a lot from the 2m PLA windturbine, and have decided to incorporate it in a smaller windturbine to test everything out. As we want to print everything with…
Testing the 2m PLA windturbine
First test run!
We have succesfully tested the PLA windturbine out in the field! It went well up to 17V in a light wind, which means that the generator is performing as should…
Try if the bearing fits. If not, make the gap a bit bigger with a soldering iron
Update on 3D-printing the generator
We have been working tirelessly on printing the generator. This part is the heart of the windturbine and will fit the magnets and bearings. Hence print settings are really important…